QuStream AAB6214 Technical Manual - Chapter 2 Introduction
Integrity 600 – AAB6214 Analog Audio DA
Publication 81-9059-0631-0, Rev. A
July 2008
Proprietary Information of QuStream
2-1
Chapter 2 Introduction
2.1
D
ESCRIPTION
QuStream’s AAB6214 Analog Audio Distribution Amplifier is a member of the Integrity 600 Series of
video and audio processing products, featuring “Fortel Inside” Technology. It mounts in the FRM603
Chassis Frame and accepts an input of analog audio and provides multiple outputs of the audio signal.
Redundant power and control are optionally available to every processing module through the chassis
frame.
The AAB6214 dual input module is actually composed of two independent DAs – configured as dual
1X7 distribution amplifiers. Figure 2-1 shows, for reference only, a typical 600 Series module with a
single-width rear panel attached to the main circuit board.
Figure 2-1 Typical 600 Series Module
Primary Features
•
Distribution amplifier with audio processing.
•
2 analog audio inputs with seven audio outputs for each input (Dual 1X7).
•
Full audio processing with independent or group gain, channel swapping, phase inversion
and summing.
•
Rear-panel 6-pin detachable connectors for input and output signals.
•
Redundant power, reference and control are optionally available to every board for
increased reliability.
•
Field-configurable when installed in a FRM603 Frame equipped with the NET603 Frame
Controller.