QuStream AAB6214 Technical Manual - page 14

I

NTEGRITY 

600

–

AES600

F

AMILY

Publication 81-9059-0632-0, Rev. A 

June 2008

Proprietary Information of QuStream

3-7 

3.4

I

NITIAL 

P

OWER

-U

P

It is not necessary to remove power when installing the AAB6214 module into an active chassis frame.  

If this is an initial installation, before applying power for the first time, please take time to go back and 

verify the following: 

•

Check for electrically sound connections, proper connector placement and possible wiring 

errors.  

•

Ensure that the chassis frame has a connection to a source of in-house sync, if required for the 

application.  

•

Check that all 600 Series modules, rear panels, power supply and controller modules are 

securely installed.  

There is no power switch on the frame, and it is powered-up simply by connecting the main power cord 

to a source of primary power. Systems with redundant power supply modules have two main power 

cords, each of which must be connected to a source of primary power. 

When the AAB6214 module is initially powered up, look at the status LEDs located on the module 

circuit board and verify proper operation as discussed in Paragraph 3.5.  

3.5

AAB6214

S

TATUS 

LED

S

There are 5 status LEDs located on the circuit board of each AAB6214 module, as shown in Figure 3-5.