R82 Rabbit User Manual - page 13
13
D
e
G
A
B
C
H
G
B
HiP SUPPoRT,
ReAR
follow the description below to mount the hip
support correctly:
* Mount two square plates in the slots on both
sides of the centre bar.
* Mount bolts (A) in the upper square plates
and fasten at the desired height using the
enclosed 6 mm allen key.
Be aware that the height of the top square
plates is the same on both sides of the
centre bar. if not, adjust into position.
* Mount the fitting from the hip support on the
top bolts.
* Mount bolts (B) in the lower square plates.
Move the bolts and plates upwards until they
fit into the fitting from the hip support. fasten
all bolts securely using the enclosed 6 mm
allen key.
* fasten the fingerscrew (C) through the hole
in the fitting to secure the fitting from the hip
support to the centre bar.
* loosen the handle (e) and pull out (unlock)
the security lock (D) to adjust the hip supports
in depth. Adjust into desired position, push in
(lock) the security lock and fasten the handle.
Make sure the security lock is pushed in
(locked) after adjustment.
* loosen the handle (G) to adjust the hip sup-
port in height.
Use the enclosed 6 mm allen key to loosen the
bolts (H) and adjust the supports individually in
height and width. (not possible for size 1)
Make sure the fingerscrew (C) is fastened
before use.
GB