R82 Rabbit User Manual - page 8
8
B
A
C
D
e
G
B
HeiGHT
ADjUSTMenT of
DRivinG WHeelS
The height of the driving wheels can be adjusted
to fit the desired height-to-floor on the small
casters. The Rabbit is delivered with max. 1 cm
height-to-floor on the casters.
follow the description below to adjust the height
on the driving wheels.
* Dismount the driving wheels
* Dismount the drum brake (A) using a 3 mm
Allen key and 8 mm wrench.
* Dismount the wheel suspention (B) using a
17 and 24 mm wrench.
* Mount the small plate (C) in the desired
position. Mount bolts and nuts as shown on
the drawing. fasten with a 17 and 24 mm
wrench. fasten the lock-nut (D) with a 24 mm
wrench.
Please be aware that the small plate (C)
is mounted at the same height on both
sides of the frame. further the small dent
in the plate must be either up or down in
both sides.
* Mount the drum brake (e) in the holes in the
plate depending on where the wheel suspen-
sion is mounted. Use a 3 mm Allen key and
a 8 mm wrench to mount the drum brake.
Mount bolts, washers and nuts as shown on
the drawing.
Please be aware that the heigh-to-floor on
the small casters not exceed 15 mm
GB