Racers Edge SureCharge 2000 LiPo Operating Manual - page 11
LITHIUM BATTERY CHARGING
Fast Charge Mode
Charging current will become lower when it progress to the end of
charging. A specific CV process will be reduced to end the charging
process earlier. In fact, the charging current will goes to 1/5 when the
charging process comes to 1/10. Charging capacity will be a little
smaller than normal charging, but charging time will be shortened
accordingly.
Press START/ENTER key to display voltage confirmation. Then press
START/ENTER key again to confirm and begin to charge.
This screen shows the real-time status of “fast charging”. Press
BATT TYPE/STOP key once to stop the charge process.
Storage Control of Lithium Battery
This function is for charging/discharging batteries which are not used at once. This program is
designed for charging or discharging of batteries of specific original state. They are classified by
types: 3.75V Lilo, 3.85V LiPo and 3.3V LiFe. The program will begin to discharge if the original
state of the battery exceeds the voltage level of storage.
STORAGE CONTROL OF LITHIUM BATTERY
At this screen, you can set up the current and voltage of the battery
pack. Charging and discharging will make the batteries come to the
voltage level of “storage” state.
This screen shows the real-time status charging. Press BATT TYPE/
STOP key once to stop the charge process.
DISCHARGING LITHIUM BATTERIES
The value of discharge current on the left cannot exceed 1 C, and the
value on the right cannot be under the voltage recommended by the
manufacturer to avoid deep discharging. Press START/ENTER for
more than 3 seconds to start charging.
This shows the real-time status of discharging, you can press BATT
TYPE/STOP key to stop discharging.
20
21