Racers Edge SureCharge 2000 LiPo Operating Manual - page 15
PROGRAMMING INFORMATION
It comes to the final voltage when the program ended.
3-pin connector is selected to be the USB port.
The external temperature is displayed when the temperature probe is used.
Present input voltage.
The battery is connected with each port through cable; you can check
voltage of each cell in the battery pack. When the cable is connected with
the ports on the right of the charger, the program will display voltage of up
to 6 batteries. The battery pack needs an output connector connected with
each cell.
WARNING AND ERROR INFORMATION
The SureCharge 2000 incorporates a variety of functions for the systems to verify processes and
the state of the electronics. In case of an error the screen will display the cause of error and emit
an audible sound.
Incorrect polarity connected.
Battery connection is interrupted.
Short-circuit of the output termination.
Erroneous selection of voltage of Lithium pack, please check the voltage of
the battery pack.
The voltage of the battery pack has been selected incorrectly!
The charger has malfunctioned for some reason. Disconnect from battery
first, then AC or DC power supply. Reconnect AC or DC power after a few
moments. If the error remains the same contact customer support.
The voltage is lower than which is set. Please check the number of cells in the
battery pack.
28
29