Racers Edge SureCharge 2000 LiPo Operating Manual - page 13
CYCLING OF NICD/NIMH BATTERY
You can set up sequence on the left and the number of cycles on the
right. You can balance, refresh and break-in the battery with this
function you can set a temporary cool-off procedure in the user’s
setting. Range of the cycle number is 1-5.
Press BATT TYPE/STOP key to stop program, you can press START/
ENTER key to alter charge current. The sound indicates the end of
program.
When it approaches to the end, you can see the capacity of the battery
being charged or discharged. You can press INC or DEC key to display
result of each cycle.
Pb (lead-sulphuric acid) Battery Program
This program is only suitable for charging Pb (lead-acid) battery with nominal voltage from 2
to 20V. Pb (lead-acid) battery is completely different from NiCd/NiMH battery. These batteries
can only deliver current lower in comparison to their capacity. The same restriction applies to the
charging process. Consequently, the optimum charge current can only be 1/10 of the capacity. Pb
battery cannot be used for fast charging, please follow the instructions provided by the battery
manufacturer.
You can press START/ENTER key to make it blink and alter the value of parameters using INC
or DEC key, press START/ENTER key to store the value.
CHARGING PB BATTERIES
Set up the charge current on the left and nominal voltage on the
right. Range of current is 0.1-5.0A; the voltage should match the
battery being charged. Press START/ENTER key for more than 3
seconds to start charging.
The screen displays the real-time discharging status. Press START/
ENTER key to alter discharge current. Press START/ENTER key
again to store the parameter value you set. Press BATT TYPE/STOP
key to end the program.
Discharging Pb Batteries
Set up the discharge current on the left and nominal voltage on
the right. Range of discharge current is 0.1-5.0A; the voltage should
match the battery being charged. Press START/ENTER key for
more than 3 seconds to start discharging.
The screen displays the real-time discharging status. Press START/
ENTER key to alter discharge current. Press START/ENTER key
again to store the parameter value you set. Press BATT TYPE/STOP
key to end the program.
24
25