Racktivity ES2000 Seriesl User Manual - Snmp Configuration
© 2011 Racktivity NV
29/52
Antwerpsesteenweg 19 - 9080 Lochristi - Belgium - www.racktivity.com
v 2014.3.27
SNMP Configuration
The EnergySwitch offers SNMPv2 communication (GETs, SETs and traps). Notifications (traps) can
be enabled or disabled for many of the device’s functions:
Outlet state change
Outlet thresholds (current, power, …)
Totals thresholds (current, power, …)
Temperature thresholds
Voltage thresholds
Overheat protection
…
To toggle SNMP for a specific parameter or function, (un)check that parameter’s checkbox and
press the Save button. The SNMP checkboxes can be found next to most measurements.
SNMP Settings
path: Settings > Network Settings
The Network Settings contains both the Network and the SNMP related settings. The network
related settings can be found in the Network Configuration chapter. The following SNMP settings
are editable:
SNMP Community read
The community read string for GET requests
SNMP Community write
The community write string for SET requests
SNMP Trap Community string
Community string used when sending SNMP traps
SNMP Trap Receiver port
The port (1 - 65535) on which traps will be sent
SNMP Trap Receiver IP
IP address of the trap receiver
Enable SNMP write protection
Check this box to disable SNMP write (SET) access to the EnergySwitch completely
Enable SNMP Traps for device
The EnergySwitch will not send any traps when unchecked, regardless of individual
settings
Use ECS authentication
Toggles the use of an external authentication server
ECS Authentication server IP
The IP address of the authentication server
ECS Authentication server port
The port (1 - 65535) of the authentication server on which the connection will be made