Racktivity ES2000 Seriesl User Manual - Resetting Measurements
© 2011 Racktivity NV
32/52
Antwerpsesteenweg 19 - 9080 Lochristi - Belgium - www.racktivity.com
v 2014.3.27
Resetting Measurements
For many parameters the minimum, maximum and/or total is saved to give an easy overview of
load activity. These values van be easily reset by pressing the Reset link for that value.
The following parameters have resettable values:
Individual & total amperage
o path: Power > Current
Individual & total wattage
o path: Power > Power
Individual & total power factor
o path: Power > Power
Individual & total real energy (kWh)
o Note: The Accumulated kWh counter is not resettable!
o path: Power > Energy
Individual & total Apparent Energy (kVAh)
o Note: The Accumulated kVAh counter is not resettable!
o path: Power > Energy
Temperature
o path: Environment > Ambient
Voltage
o path: Environment > Electrical
Note: Clicking a Reset link in the column header will reset all values in that column, except for
the value in the Total row.
Startup Delay
path: Settings > Startup Delay & Outlet Importance
The startup delay shown in the table is the time in seconds at which the designated outlet will
switch on after boot. By default the delay is set incrementally over the outlets to reduce the
overall power peaks of booting loads.
Note: An outlet will only switch on at boot if it was on before the EnergySwitch was powered
down.