RAD DIGITAL B- User Manual - page 16
Digital B-RAD USER MANUAL
New World Technologies Inc.
Page • 14
V2014.07.03
4. Use the “Up Arrow” button and the “Down Arrow” button to highlight the “Life
Cycles” option.
5. Press the “Centre” button to select the “Life Cycles” option.
Result: The Life Cycles screen will be displayed (Figure 3.3.5-3).
Figure 3.3.5-1: Main Menu Screen
Figure 3.3.5-2: Info Menu Screen
Figure 3.3.5-3: Example of Life Cycles
Screen
3.3.6 View Maintenance Cycles
This function allows the operator to view the statistics of all the Cycles conducted since the
tool’s last maintenance.
To view Maintenance Cycles:
1. Press the “Centre” button.
Result: The Main Menu screen will be displayed (Figure 3.3.6-1).
2. Use the “Up Arrow” button and the “Down Arrow” button to highlight the “Info”
option.
3. Press the “Centre” button to select the “Info” option.
Result: The Info Menu screen will be displayed (Figure 3.3.6-2).
4. Use the “Up Arrow” button and the “Down Arrow” button to highlight the “Maint
Cycles” option.
5. Press the “Centre” button to select the “Maint Cycles” option.
Result: The Maintenance Cycles screen will be displayed (Figure 3.3.6-3).
Figure 3.3.6-1: Main Menu Screen
Figure 3.3.6-2: Info Menu Screen
Figure 3.3.6-3: Example of
Maintenance Cycles Screen
3.3.7 Change the Target Torque
This function allows the operator to change the Target Torque. The Target Torque is the
torque value at which the Digital B-RAD will stop the Torque Cycle and the cycle will be
considered a pass. For more information on the Target Torque and Torque Cycle, refer to
Section 4.2 – Torque Operation.
Note: Refer to Section 1.2.1 – Torque Ranges for more information.