RAD DIGITAL B- User Manual - page 4
Digital B-RAD USER MANUAL
New World Technologies Inc.
Page • 2
V2014.07.03
IMPORTANT SAFETY NOTICE
RAD TOOLS ARE SAFE AND RELIABLE. NOT FOLLOWING PRECUATIONS
AND INSTRUCTIONS OUTLINED HERE CAN RESULT IN INJURY TO THE
TOOL, OPERATOR AND FELLOW WORKERS.
NEW WORLD TECHNOLOGIES INCORPRATED IS NOT RESPONSIBLE FOR
ANY SUCH INJURY.
Digital B-RAD Tool System Safety
The intended use of the Digital B-RAD Tool System is for commercial and
industrial bolting applications.
Do not operate the Digital B-RAD Tool System before reading and understanding
this user manual and noting the Safety Notices displayed on the Digital B-RAD
Tool System and throughout this manual.
Only qualified personnel with training in the safe operation of torque tooling and
the Digital B-RAD Tool System should attempt the installation, operation and
diagnosis of the Digital B-RAD Tool System.
The Digital B-RAD Tool System is connected to high voltage power and consists of
external rotating parts. Improper training and use can cause serious or fatal
injury.
Do not disassemble or attempt to repair the Digital B-RAD Tool System; doing so
will void warranty. If breakdown, malfunction or damage occurs and the Digital B-
RAD Tool System fails to operate correctly, contact New World Technologies Inc.
Technical Support (refer to Section 6.0 – Contact Us).
The Digital B-RAD Tool System should only be used if environmental storage and
operation specifications have been met. Refer to Section 1.2.3 – Environmental
Specifications.
Do not operate the Digital B-RAD Tool System in explosive atmospheres, including,
but not limited to, the presence of flammable liquids, gases or dust. The Digital B-
RAD Tool System creates sparks which could ignite these substances.
Do not expose the Digital B-RAD Tool System to wet conditions. Water in the
Digital B-RAD Tool System will cause damage to the tool and increase the risk of
electric shock.
After long durations of use, the Digital B-RAD Tool System will become hot. It is
recommended to use the tool in short intervals and allow for cooling between uses
to prevent injury to the operator or damage to the Digital B-RAD Tool System.
While operating the Digital B-RAD Tool System, always wear safety goggles and
keep all body parts clear of moving parts and the reaction arm contact point.
Never exceed the Maximum Torque of the Digital B-RAD Tool System. Failure to
comply will result in void warranty.
The Digital B-RAD Tool System has been calibrated by a qualified Calibration
Technician; calibration must be done by a qualified Calibration Technician.
Improper calibration can cause damage to the tool and joint.