RAD DIGITAL B- User Manual - page 7
Digital B-RAD USER MANUAL
New World Technologies Inc.
Page • 5
V2014.07.03
1.2.3 Environmental Specifications
CAUTION!
Only operate the Digital B-RAD Tool System if the following environmental storage and
operation specifications have been met.
Temperature Ranges
̊ C
̊ F
Operating Temperature
0 – 35
32 – 95
Charging Temperature
0 – 50
32 – 122
Storage Temperature
-25 – 70
-13 – 158
Humidity
10% to 90% non-condensing
Shock
10G according to DIN IEC 68-2-6/29
Vibration
1G, 10-150Hz according to DIN IEC 68-2-6/29
Required Operating Conditions
-
Non explosive atmosphere
-
Dry location
Table 3: Environmental Specifications
2.0 Tool System
The following sections give a visual and functional description of the Tool Handle,
Navigation Keypad, RAD Li-Ion Battery Pack and RAD Battery Charger.
2.1 Tool Handle
The Digital B-RAD (Figure 2.1-1) is trigger activated with a Forward/Reverse Switch. The
RAD Li-Ion Battery Pack is attached to the bottom of the Tool Handle and the LCD Display
is located on the top of the Tool.
1. On/Off Trigger – tool activation
2. Forward/Reverse Switch – controls direction of rotation
3. RAD Li-Ion Battery Pack – refer to Section 2.3 – RAD Li-Ion Battery Pack
4. Battery Release Button – refer to Section 2.3.1 – Insert/Remove the RAD Li-Ion
Battery Pack
5. LCD Display – status display with access to menus and controls
Figure 2.1-1: Digital B-RAD
2.1.1 Trigger Lock
The Trigger Lock is useful while transporting or storing the Digital B-RAD. The Trigger Lock
disables the use of the On/Off Trigger, therefore disabling the tool. It is suggested that
while the Digital B-RAD is not in use, the Trigger Lock should be enabled.
To enable the Trigger Lock:
1. Slide the Forward/Reverse Switch to the Centre Position (neither fully to the right
nor fully to the left).
Note: The On/Off Trigger cannot be depressed.
To disable the Trigger Lock:
1. Slide the Forward/Reverse Switch to the Forward Position or the Reverse Position.
Note: The On/Off Trigger can be depressed.
1
2
4
3
5