RAD Smart Socket User Manual - page 10
SMART SOCKET USER MANUAL
New World Technologies Inc.
Page • 8
V2014.07.03
3. Socket Retaining Pin Hole/Retaining O-Ring Groove – Used with the supplied
Retaining Pin and O-Ring (or set screw) to retain the Socket to the user supplied
tool’s Square Drive.
4. Screen - Displays Battery Charge, Mode, Status, and Measured Torque.
5. Keypad - For wake-up and setting selection.
6. Charging/Comms Port – Used with supplied USB Charger/Comms Cable to connect
the Smart Socket to a PC for the purpose of charging the internal Lithium Polymer
battery, device configuration, and downloading Data Logs.
7. Reset Button – Located on the back of the Smart Socket, the Reset Button can be
used to reset the Smart Socket. It can be pressed with a 1.5 metric Allen Key or
something of similar size.
Note: The Smart Socket holds 360 Log Records. When display reads “logs full”, download the Logs to
the Data Logger and close Logs. Refer to Section 5.3 – Downloading All Data Logs, for more details on
this operation.
4.0 General Operation
This Smart Socket provides a simple display and three button keypad for measuring torque
operations.
WARNING!
Read, understand and strictly follow all Safety Instructions, Warnings, and Cautions provided
in the user manual prior to use.
CAUTION!
The display is LCD and protected by a lexan cover, however the display is susceptible to
mechanical shock which may result in damage and failure. Use with due care and caution to
protect the Smart Socket from impacts.
The performance of the display will degrade under high temperature and humidity; avoid
such conditions during use and in storage.
4.1 Preparing for Bolting
To use the Smart Socket for bolting operations:
1. If the device is in Sleep Mode, wake the device as detailed in Section 4.2 –
Sleep/Wake.
2. Check
the
battery
charge
is
sufficient
for
operations,
if not, charge the device as detailed in Section 2 – Battery Usage and Charging.
3. Prior to deployment, configure the device as detailed in Section 6 – Pre-Deployment
Configuration.
4. Set the Measurement Method. Refer to Section 4.3 – Measurement Method, for more
information.
5. Install the Smart Socket on the toolas recommended by the Tool Manufacturer and
NWT. Refer to Section 4.4 – Installation, for more information.
4.2 Sleep/Wake
To conserve battery power the Smart Socket will go to sleep after 10 minutes of inactivity on
the keypad. This time can be changed, refer to Section 6.1.4 – Tool Uptime, for information
on how to do this.
Note: While the device is in Sleep Mode the screen will be blank.
To wake the Smart Socket from sleep:
1.
Press the keypad centre button
2.
If screen is still blank, connect the Smart Socket to a computer and press the centre
button.
3.
If screen is still blank, press the reset button on the back of the Smart Socket while
it is still plugged in.
4.
If the screen is stiil blank, charge the battery for 15 minutes before trying again. If
the problem persists contact your NWT Distributor for assistance.