RAD Smart Socket User Manual - page 8
SMART SOCKET USER MANUAL
New World Technologies Inc.
Page • 6
V2014.07.03
1.2.1 Model Specifications
Max. Torque Range (FtLb)
Model
Max. Torque Range (Nm)
75-1500 FtLb
33 mm 1” Square Drive
100-2034 Nm
75– 1500 FtLb
46 mm 1” Square Drive
100-2034 Nm
150 – 3000 FtLb
50 mm 1” Square Drive
200– 4068 Nm
150 – 3000 FtLb
55 mm 1.5” Square Drive
200– 4068 Nm
150 – 3000 FtLb
60 mm 1” Square Drive
200– 4068 Nm
400 – 8000 FtLb
80 mm 1.5”Square Drive
540– 10848 Nm
Table 1.2.1: Model Specifications
1.2.2 Charging Specifications
Units
240 mAh
Charge Time
Hours
Approx. 1
Storage Time (Must be fully Charged)
Months
3-4
Table 1.2.2: Charging Specifications
1.2.3 Environmental Specifications
All Models
Ambient Operating
Temperature Range
°C
°F
Optimum Battery Life
5 to 35
41 to 95
Absolute Maximum
1 to 60
34 to 140
Ambient Charging
Temperature Range
°C
°F
Temperature at Charging
0 to 45
32 to 113
Storage Temperature
Range
°C
°F
Optimum Battery Life
-20 to 45
-4 to 113
Storage More than 3 Months
0 to 30
32 to 86
Humidity
10% to 90% non-condensing
Table 1.2.3: Environmental Specifications
2.0 Battery Usage and Charging
This section provides instructions for safe usage and charging of the Smart Socket internal
LiPo battery.
WARNING!
Do not operate the tool or charge the batteries before reading the safety instructions and
warnings detailed in this manual. If breakdown, malfunction or damage occurs, DO NOT
attempt to repair; contact New World Technologies Inc. or your local distributor immediately.
WARNING!
Lithium Polymer (LiPo) batteries are volatile.
Failure to read and follow these instructions may
result in fire, personal injury and/or damage to property if charged or used improperly.
2.1 General Safety Warnings and Guidelines
The Smart Socket is assembled, calibrated and shipped with a rechargeable Lithium Polymer
(LiPo) battery.
1. Batteries are NOT fully charged as you receive them; they may contain
approximately 50% of a full charge.
2. Use the New World Technologies Inc. supplied USB charger only. Do not use any
other Lithium Polymer or NiCd or NiMh charger. Failure to comply may cause a fire,
which may result in personal injury and/or property damage.
3. Never charge the tool unattended.
When charging LiPo batteries you should always
remain in constant observation to monitor the charging process and react to
potential problems that may occur.
4. Charge in an isolated area, away from flammable materials.
5. Let the Smart Socket and battery cool down or warm up to recommended ambient
temperature before charging.