RAD Smart Socket User Manual - page 11
SMART SOCKET USER MANUAL
New World Technologies Inc.
Page • 9
V2014.07.03
4.3 Measurement Method
Select the Torque Measurement Method using the Smart Socket keypad:
Peak Mode - reads Peak only and will hold it for 1 minute or until you start torqueing another
bolt.
Track Mode - constantly tracks and displays the read out of the current torque. Pressing the
centre button will hold and display the current torque for 1 minute but it will not read Peak
Torques. Press and hold the centre button to return to the Main Screen.
4.4 Installation
WARNING!
Improper installation or use of the Smart Socket can cause serious or fatal injury to the user.
DO NOT use the Smart Socket before reading all safety instructions and warnings in this
manual.
Ensure that the Square Drive size of the tool matches the Smart Socket model and check the
fit is snug.
1. Refer to Section 1 – General Information and Section 2 – Battery Usage and
Charging, to familiarize yourself with the Smart Socket models and components.
2. Inspect the Smart Socket for any apparent damage to the display, keypad and/or
body. DO NOT charge or use the Smart Socket if any component is damaged.
3. Press the centre keypad button to wake up the Smart Socket.
4. Check the displayed battery charge is sufficient for operations. If not, refer to
Section 2 – Battery Usage and Charging, for instructions and safety on charging the
Smart Socket.
5. Install the Smart Socket onto the desired tool by the Square Drive end.
6. Insert the Retaining O-Ring (if included) on the neck of the Smart Socket just below
the Retaining O-Ring Groove, such that it does not impede the insertion of the tools
Square Drive, nor the Retaining Pin.
7. Insert the Retaining Pin through one side of the Socket Square Drive, through the
mated tools Square Drive, and out the other side of the Socket.
Note: The pin should be flush on either side of the Socket Retaining O-Ring Groove and fully
engage though the tools mated Square Drive.
8. Insert the Retaining O-Ring (or set screw) into the Groove such that it holds the
Retaining Pin in place.
9. Pull on the Smart Socket away from the mated tool and ensure it is securely retained
on the tool.
The Smart Socket is now installed and ready for use.
4.5 Operation with Target Mode Disabled
During pre-deployment setup, if “Target PASS/FAIL Enable” is not selected, the Smart
Socket will be in “Audit” mode and will measure, record and display the torque according to
the measurement mode selected. No Pass/Fail indication will be displayed.
Please refer to Section 6 – Pre-Deployment Configuration,for more information and setup of
the Smart Socket.
1. Check the device status and configuration on the screen, where “XXXX” is the
selected measurement mode, either “PEAK” or “TRACK”. The screen should be
displayed as:
READY
LBFT
XXXX
READY
LBFT
PEAK
READY
LBFT
TRACK