RAD Smart Socket User Manual - page 14
SMART SOCKET USER MANUAL
New World Technologies Inc.
Page • 12
V2014.07.03
Figure 5.2-1: Setup
Screen With
Bluetooth Disabled
Figure 5.2-2: Setup
Screen With
Bluetooth Enabled
Bluetooth. Press the centre button. When Bluetooth is turned on, the screen will
read “BT ON” (Figure 5.2.2-2).
To connect the Smart Socket to the PC follow the steps below:
Note: It is recommended that a Bluetooth Dongle is used when connecting the Smart Socket to a
PC. The Bluetooth Dongle has a range that goes further than the range of a computer with
integrated Bluetooth.
a. Right click the “Bluetooth Devices” icon in the bottom right of the screen.
b. Click “Add a Bluetooth Device”.
c. Click the serial number of the Smart Socket that you want connected.
d. Enter the correct Pairing Code.
Note: The default Pairing Code is “1111”. Refer to Section 5.7 – Changing the Bluetooth
Pin, for information on how to change the Pairing Code.
2. Open the RT Data Logger Software.
3. Select “Scan All Active Transducers” from the bottom of the screen (Figure 5.2.2-
3). The Smart Socket should now be connected to the PC. Proceed with configuration
or data download as detailed further in this section.
Figure 5.2-3: Scan All Active Transducers
Note: For troubleshooting, refer to Section 7.2 – Turning On Bluetooth: Troubleshooting.
5.3 Downloading all Data Logs
Note: The Smart Socket holds 360 Logs.
Using the RT Data Logger Software, the operator is able to download the stored Data Log
from the Smart Socket to the PC.
1. Press the “Download Logs” button on the Main Screen (Figure 5.3-1).
2. The PC program will download all the data from the device.
3. You will be prompted to add descriptions of the tool and the Data Logs once the Log
has been downloaded. These descriptions can be anything to help you identify the
data.
Figure 5.3-1: Download Logs Button
5.4 Deleting (Closing) Data Logs
Closing Data Logs allows the operator to remove the Log from the device. This information
will remain on the PC. The title of the closed Log will be automatically modified to represent
the date it was closed.
To close a Data Log:
1. Select the Log you would like to close.
2. Select “Close Logs” located under the “Tool” tab or press the “Close Logs” button
SETUP
BT OFF
SETUP
BT ON