RAD Smart Socket User Manual - page 5
SMART SOCKET USER MANUAL
New World Technologies Inc.
Page • 3
V2014.07.03
IMPORTANT SAFETY NOTICE
RAD TOOLS ARE SAFE AND RELIABLE. NOT FOLLOWING PRECUATIONS
AND INSTRUCTIONS OUTLINED HERE CAN REUSLT IN INJURY TO THE
TOOL, OPERATOR AND FELLOW WORKERS.
New World Technologies Inc, its distributors and retailers assume no liability for
failures in compliance with these warnings and safety guidelines.
By purchasing this tool system and battery, the buyer assumes all risks associated
with this product. If you do not agree with these conditions, refrain from using the
tool.
WARNING!
Do not operate the tool before reading this user manual. If breakdown, malfunction
or damage occurs, DO NOT attempt to repair. Contact New World Technologies
Inc. or your local distributor immediately.
Only persons trained and qualified should attempt the installation, operation and
diagnosis of this equipment.
WARNING!
Intended use of this equipment is for commercial and industrial bolting
applications. The tool should only be used if the equipment is protected from
exposure to excessive or corrosive moisture, dust, dirt, ambient temperatures,
vibrations and impacts.
BEFORE using the Smart Socket, unpack the device and all accessories to
ensure you have all components listed in Section 1.1 – Receiving and
Inspection.
BEFORE using your Smart Socket, read all instructions and warnings in this
manual and understand the safe use of this product.
ALWAYS
wear safety goggles during operation.
ALWAYS
make sure the Socket is fitted properly to a tool with the Retaining
Pin and O-Ring before you operate the tool and Socket.
ALWAYS
make sure the Socket is fitted properly to the fastener before you
operate the tool and Socket.
ALWAYS
keep your body parts clear of the Socket during operation.
ALWAYS
safely support the system during use, while ensuring body parts
are clear of any rotating parts and pinch points. The system must be
supported at all times in order to prevent unexpected release in the event
of fastener or component failure.
NEVER
exceed the Maximum Socket Rated Torque. Failure to comply voids
warranty.
NEVER
use the Smart Socket without understanding and following the
safety instructions and warnings in this manual.