Radio Shack ITZA 2 Owner's Manual - page 11
9
Operation
• To store an upper memory location,
simply press a memory location but-
ton (M1–M10).
• To store a lower memory location,
press
LOWER
, then press a memory
location button (M1–M10).
5. Hang up the handset or press
SPK-
PHONE/HEADSET
again.
Note: To keep a record of each stored
number, use a flat-blade screwdriver to
lift the plastic cover from the telephone
number index card. Write the name on
the index card. For easy reference, you
can use the shaded areas for upper
memory numbers and the blank areas
for lower memory numbers. Use a pencil
in case you want to change it later.
Storing the Last Number Dialed in
Memory
1. Pick up the handset or press
SPK-
PHONE/HEADSET
.
2. Press
STORE
.
3. Press
REDIAL/PAUSE
, then enter the
memory location.
Note: You can store the very last num-
ber dialed by pressing
REDIAL/PAUSE
,
but you should not press any digits
before pressing
REDIAL/PAUSE
. Other-
wise, the number will be stored as a
pause.
Entering a Pause
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the necessary connection time.
1. Press
REDIAL/PAUSE
to enter a 2-sec-
ond pause.
2. Press
REDIAL/PAUSE
again for a longer
pause.
Note: Each Pause entry uses one digit
of memory.
Dialing a Memory Number
To dial a number stored in an upper memory
location, press the desired memory location
button.
To dial a number stored in a lower memory,
press
LOWER
then the desired memory loca-
tion button.
USING ANOTHER LINE
DURING A CONVERSATION
To make a call on another line:
1. Press
HOLD
to place the first call on
hold.
2. Press the other
LINE
button.
3. Press the first call’s
LINE
button at any
time to return to the first call.
To answer a call ringing on another line:
1. Press
HOLD
to place the first call on
hold.
2. Press the flashing
LINE
button to answer
the incoming call.
To switch between lines:
1. Press
HOLD
to place your current call on
hold.
2. Press the other
LINE
button to make or
answer another call.
Note: If AC power fails, the telephone
can only be operated with Line 1.