Radio Shack ITZA 2 Owner's Manual - page 7
5
Installation
MOUNTING THE PHONE
You can place the telephone on a desk or ta-
ble, or mount it on a standard wall plate or di-
rectly on a wall. Choose a location that is
near an AC outlet and a modular telephone
line jack, and out of the way of normal activi-
ties.
On a Desktop
Use the supplied mount-
ing bracket as a stand
when you place the
phone on a desk, shelf,
or table. You can also
place the phone on a
desk without the bracket.
Insert the mounting
bracket’s tabs into the
slots on the bottom of the
phone with the arrows engraved on the
bracket pointing to the front of the phone.
Then push the bracket down until it snaps
into place.
On a Wall Plate
1. Align the adapter’s power cord and
modular cord on the top of the mounting
bracket. Pull the other end of the modu-
lar cord through the large hole in the
center of the bracket.
2. Insert the mounting bracket’s tabs into
the slots on the bottom of the phone with
the engraved arrows pointing to the
back of the phone. Then pull the bracket
up until it snaps into place.
3. Coil the excess modular cord in the
recess of the mounting bracket by push-
ing it back through the large hole. Leave
only about 1–2 inches of cord outside
the bracket.
4. Plug the exposed
end of the cord
into a wall plate
jack.
5. Line up the key-
hole slots on the
bracket with the
studs on the wall plate, then slide the
bracket down onto the wall plate until it
is secure.
Directly on the Wall
Use a drill, screws with heads that fit the key-
hole slots on the bottom of the mounting
bracket, and the supplied mounting bracket
to mount your phone directly on the wall.
1. Drill two holes 3
1
/
4
inches apart, one
below the other.
2. Thread a screw
into each hole,
letting the heads
extend about
1
/
8
inch from the
wall.
3. Align the adapter’s power cord and
modular cord on the top of the mounting
bracket. Pull the other end of the modu-
lar cord through the large hole in the
center of the bracket.
4. Insert the mounting bracket’s tabs into
the slots on the bottom of the phone with
the engraved arrows pointing to the
back of the phone. Then pull the bracket
up until it snaps into place.
5. Plug the exposed end of the cord into a
modular phone jack wall plate.
6. Fit the head of the screws into the key-
hole slots on the bottom of the bracket,
then slide the phone down until it is
secure.