Radix Epsilon 1 FTA User Manual - Programming Your Receiver
Page 34
Version 1.0
9.3.3
Programme Data Transfer
This menu item is included to support specialist retailers. In this way a desired preset can be trans-
ferred from a master device to several slave devices. This pre-setting serves the common interests of a
group of customers, for example regional or ethnic interests.
Master and slave receivers are linked together using as RS 232 interface.
NOTE:
All receiver functions are locked while the receiver is in data transfer mode. The transfer of data can
only be interrupted by removing the mains cable.
9.3.4
Reinstallation
If you changed or deleted the preset data, you can reset the receiver to the factory settings. To do this
you will need the PIN number (Section 9.4).
9.3.5
Transponder Editor
You can change, add or delete all satellite data. This function is intended only for servicing purposes
and has no effect whatsoever on the operation of your receiver.
NOTE:
If you delete all of the data for a satellite, the satellite itself is also deleted.
9.3.6
Delete all Channels
CAUTION:
When you carry out this function (PIN number needed) all settings are deleted and you will need to
reprogramme your receiver!
If you want to replace the entire program information, delete all programs. Your receiver now displays
the “Welcome” menu as described in Section 6.
9.4
Access Manager
Several functions on your receiver can only be
accessed using a PIN number – the factory default is
0 0 0 0
.
You can set up an access lock to prevent unauthor-
ised access to the receiver.
• Under menu item 4, enter your PIN number and
activate the access control.
When you do this, you will need to enter the PIN
number each time you turn the receiver on.
To prevent certain programs from being viewed you
can set up a program lock in the same way as described above. When you do this you will need to
enter the PIN number each time the program is changed.
If necessary you can change the PIN number using menu item 1.
NOTE:
In case of emergency: If you forget your PIN number, your local stockist can request a general PIN for
your receiver from the factory.
Access Manager
TV
1. Change PINcode
2. Parental Lock/Unlock
3. Access Lock
Exit
Menu
Back
Main menu
Go Back
Choose the setting you wish to change
with [UP/DN] and select with [OK].