Radix Epsilon 1 FTA User Manual - Using Your Receiver
Version 1.0
Page 27
GB
Using Your Receiver
When you have completed these settings, you are ready to begin viewing the pre-programmed chan-
nels. To do this you must first activate the factory presets:
• Press the Exit key to download the channel data. After a few moments you will receive a television
programme.
If you do not want to use the factory presets, you can open the Main Menu by pressing the Menu key
(see Section 9) and make all of the necessary changes yourself.
7
Using your Receiver
7.1
Switching your Receiver On
Press the ON/OFF button on either your receiver or the remote control unit to switch the receiver
between on (“ON” or channel number on the display) and Standby modes (dot on display).
7.2
Selecting a Channel
• Use the number keys to select the channel of your
choice or select one from a preference list.
NOTE:
The channel number consists of four digits. You can
also enter a one, two or three-digit number (for
example, 1, 13, 113) and the receiver will display the
channel in a few seconds.
• Use the UP button to move up one channel; use the
DOWN button to move down one channel.
• Press the LAST button to return to the last channel
you viewed.
Each time you change channels, the channel name and number, the time and the current programme as
well as the following programme are displayed along with their times for a number of seconds. You can
display this information at any time by pressing the INFORMATION button.
7.3
Volume Control / Mute Sound
• Use the volume buttons on the remote control
to adjust the volume.
The on-screen display disappears after a few
seconds if no changes have been made.
• To turn off the sound, press the MUTE button (see Section 4.1):
• Press the MUTE button again to restore the sound.
20:20
Pro 7
0001
Exit
20:15 Südseeparadies
22:00 News
Volume
15
MUTE