Rainforest EAGLE User Manual - Eagle
EAGLE
™
User Manual
11
EAGLE
™ Status LED Lights
Your EAGLE
™ has four LED lights at the front of the top of the device. These lights
give you a quick way to check the status of your device.
Power LED
– shows that the device is powered on. It should always be on
when the unit is plugged in.
Ethernet LED
– shows the status of the connection to the local Ethernet
network. When the link is active, the light will be flashing. When an IP address
is obtained, the light will be on constantly.
Cloud LED
– shows the status of the connection to a cloud service. When
the user has enabled the cloud service, the light will be flashing. When
successfully sending and receiving data with the cloud service, the light will be on
constantly.
ZigBee LED
– shows the status of the ZigBee link to the meter. Initially, it will
flash briefly once per second. Once the meter has been found, the light will flash
longer every three seconds. Finally, when the connection to the meter is
established, the light will stay on continuously.
Normally, all four LED lights should be on continuously when the unit is in normal
operation.