Rainforest EAGLE User Manual - Eagle
EAGLE
™
User Manual
5
Quick Setup
Step 1: Prerequisite software and hardware
1) Access to an Ethernet connection directly connected to the Internet.
2) A PC or other device with a web browser and an internet connection (for
access to cloud service).
Step 2: Provision the EAGLE
™
Your EAGLE
™ must be registered with your utility to connect to the smart meter.
You will need to contact your utility with two numbers (MAC Address and Install
Code) that can be found on the Information Label on the underside of your
EAGLE
™:
Note that it may take some time for your utility to enable the smart meter to
connect with your device. You must wait until this process is complete before
proceeding; your EAGLE
™ will not function correctly until the smart meter is
enabled.
Step 3: Power up the EAGLE
™
1) Plug the Ethernet cable into a port on your router, and the other end into the
Ethernet port on your EAGLE
™.
2) Plug the AC adapter into a nearby wall outlet, and plug the other end into the
power socket on your EAGLE
™.
3) Allow two minutes for the device to boot up. You should see that the Power,
ZigBee, and Ethernet status LED lights are all on continuously. This indicates
that the unit is functioning normally.