Raleigh Pedelec Groove* User Manual - page 192

10  

VI User Manual Groove Pedelec

4.1   Charging  operation

Before charging the battery, read the directions on the 

charger carefully. 

Sticker on the underside of the charger 

›

1.  Take the charger provided out of its packag-

ing and plug the mains plug into a socket (230 V, 

please observe type plate on the charger).

To charge the battery safely, the charger must be 

placed on a suitable surface resting on its four feet 

with the LED facing upwards. 

›

2.  The LED in the charger now lights up green.

›

3.  Insert the plug of the charger into the battery 

charging socket. The battery and charger are con-

nected. 

Battery with charging cable plugged in

›

4.  The charging process starts.

›

The LED in the charger now lights up red.  You can 

check the battery's charge state by pressing the 

square button on the battery to the right of the 

LEDs. The greater the number of LEDs that light up 

the higher the charge state is. 

LEDs on the battery

›

5.  If the LED on the charger lights up green, the 

battery is fully charged.

›

6.  To save power, pull the charger plug out of the 

socket once the charging operation is complete.  

You can also leave the charging cable plugged in 

once the charging operation is complete. However, 

the charger always draws some current if you leave 

it plugged in.

4.2   Fitting the battery 

›

1.  Push the battery into the rear of the battery 

housing under the pannier rack. 

To do this, the battery key must be inserted and 

turned clockwise.  

Reinstalling the battery

›

2.  Push the battery fully into the battery housing. 

Now turn the key anticlockwise and then remove it 

to lock the battery. 

›

3.  Make sure the battery is firmly in place.

›

4.  Push down the round rocker switch on the left-

hand side of the battery housing. A red LED lights 

up.

›

5.   The Pedelec is now ready for operation.