RAMSET RL510 Instruction Manual - How To Use The Rl510 Laser
How to Use the RL510 Laser
13
3.
Press key (6) on the remote control to move the laser up; press key (5)
on the remote control to move the laser down. Holding the key will
result in fast movement; short clicks will move the laser more precisely.
If you don’t raise or lower the wall mount for 5 minutes, the laser will go
back to its previous mode.
2.8.3 Using the Motorized Mount and Laser on the Floor
1.
Check that the laser and mount are connected securely. The knobs
(1) should be turned fairly tight to make contact for the motor,
although do not overtighten.
2.
Flip down the support plate (8) and place the laser in vertical mode
on the floor.
3.
If the support plate is not level, use the screw (9) to adjust.
4.
Press the scanning key (4) on the remote control and hold it for
several seconds until the 3 LEDs blink on the RL510 keypad.
5.
Press keys (5) and (6) on the remote control to move the laser back
and forth. Holding the key will result in faster movement; short
clicks will move the laser more precisely.
If you don’t move the wall mount for 5 minutes, the laser will go back to
its previous mode.
2.9 Squaring
After placing the laser in the vertical position, the plumb beam out the
top of the head can be moved to the left or right. This is necessary to do
squaring for installing walls and partitions.
It is not necessary to use the motorized mount during squaring.
However, it is recommended to use the motorized mount and support
plate for more stability.
To position the rotating plane perpendicular to a reference line:
1.
Place the laser on the ground so that the index notch on top of the
adjustable plate is over your reference point.
2.
Turn on the laser. After the laser has self-leveled, stop the head
rotation using the remote control. Turn the head down so that the
beam is on the adjustable plate.