RAMSET Viper Tool Operator's Safety & Operating Instruction Manual - Disassembly
DISASSEMBLY
DISASSEMBLY
14
TOOL DISASSEMBLY
1. Unscrew and remove the barrel
retention collar. Handle the
tool carefully after the collar is
unscrewed to prevent the two
barrel pawls from falling out.
2. Remove the two pawls from the
slots on either side of the tool
housing.
3. Slide the barrel assembly and the
barrel spring out of the tool body.
Note the position of the slots on the
sides of the barrel since the tip
ends of the pawls are inserted into
the barrel slots through the tool
housing in re-assembly.
4. Unscrew the muzzle bushing
assembly from the barrel. If this is
difficult to do by hand, grasp the
barrel and use a wrench on the flats
of the muzzle bushing assembly to
loosen it for complete removal.
5. Remove the piston from the
barrel.
REMOVE BOTH PAWLS
SLIDE THE BARREL ASSEMBLY
AND BARREL SPRING OUT OF
THE TOOL BODY
UNSCREW THE BARREL
RETAINING COLLAR
UNSCREW THE MUZZLE BUSHING
FROM THE BARREL
PULL PISTON OUT OF THE
BARREL