RAMSET Viper Tool Operator's Safety & Operating Instruction Manual - Disassembly
DISASSEMBLY
DISASSEMBLY
15
6. Remove the buffer from the muzzle
bushing.
Inspect all parts for wear or damage
and clean or replace as required.
Use detergent oil and cleaning
brushes to remove dirt and powder
residues. Wipe all parts dry before
reassembly.
Wear safety goggles when
cleaning tool parts.
7. Check the piston tip for damage and
grind flat. The tip of the piston must
be 90° to the shank. Grinding should
only be done by qualified personnel.
The minimum overall length of the
piston must not be less than 4” long.
When less than 4” long, the piston
must be replaced.
8. Reassemble the tool in the reverse
order of disassembly. When sliding
the barrel and spring into the
housing, align the slot in the barrel
with the slot in the tool housing and
install both pawls and the retaining
collar
ALWAYS CHECK BEFORE USING
THE TOOL TO BE SURE THAT THE
ADVANCE LEVER CAM IS TIGHT-
ENED SECURELY ON THE END OF
THE POLE CONNECTOR.
ALWAYS PERFORM THE DAILY
FUNCTION TEST DISCUSSED
AND SHOWN ON PAGE 9
BEFORE USING THE TOOL
AFTER CLEANING OR SERVIC
ING.
GRIND PISTON TIP FLAT
AND BEVEL EDGE AT 18°
PULL THE BUFFER OUT OF THE
MUZZLE BUSHING
BE SURE THE ADVANCE CAM IS
TIGHTENED SECURELY AND IS
FLUSH WITH THE END OF THE
POLE CONNECTOR
FLUSH AND TIGHT