RAMSET Viper Tool Operator's Safety & Operating Instruction Manual - Fasteners / Loads
FASTENERS / LOADS
FASTENERS / LOADS
7
Your Ramset Viper tool uses only the Ramset fasteners and loads shown
below or listed for the tool in the Product Catalog.
DANGER
CEILING CLIP ASSEMBLIES - .300 HEAD DIA.
The power level of the loads is indicated by the number marked
on each box, the color of the box and the color on the tip of each
load. As the number increases, the power level also increases.
Always peform the center punch test described on page 3 to test
the base material.
Always make a test fastening using the # 3, Green power level
first. If more power is required to set the fastener, use the next
higher power level necessary to drive the fastener is reached
Never use any other types of fasteners or strip loads in the Viper tool.
Use of other types of fasteners or loads may cause unintentional load discharge,
damage the tool, cause poor fastening performance, or create a risk of seroius
injury to the operator or bystanders.
FASTENERS AND FASTENER ASSEMBLIES
LOADS
RS 27 10 SHOT
STRIP LOAD
POWER CATALOG LOAD
CASE
LEVEL
NUMBER COLOR COLOR
3
3RS27
Green
Brass
4
4RS27
Yellow
Brass
5
5RS27
Red
Brass
Ramset RS 27 strip loads are specially made for use in the Viper
Tool.
CAT. NO.
SHANK DIA. LENGTH
2202
.145
1 1/4”
SDC100
.145
1”
SDC125
.145
1 1/4”
SPC100*
.150/.180
1”
SPC114*
.150/.180
1 1/4”
Note: * For Hard Concrete