Rapiscan TSA TPM-903B Operation And Service Manual - page 13
TSA TPM903 Operations and Service Manual
Doc: # 5058 Rev. A
_____________________________________________________________________________________________________________________
_____________________________________________________________________________________________________________________
This document is the exclusive property of Rapiscan Systems.
Unauthorized use or distribution is strictly prohibited
7
3.3. PASSWORD CONTROL
The zero (0) key on the keypad is used to enter the set-up mode from the operating screen. Before
the menus can be accessed, the password must be input, followed by the pound (#) key. If the
password in not entered correctly, the system will return to the operating screen.
NOTE: The password is set to "1234" and cannot be changed.
3.4. PROGRAMMING THE SYSTEM
CAUTION
Always verify the calibration of the system before attempting to program the system.
All of the system parameters are controlled from the system controller which is mounted on the
"#1" pillar. In order to access the TPM-903B, the cover must be removed by removing the four
screws in the corners of the clear cover.
The TPM-903B has a twelve-key keypad on the front panel. Using this keypad, the operator can
perform system set-up and diagnostic tests.
After the system has been powered up, and acquired its initial background, the set-up menu can
be accessed. The parameters and diagnostic functions are protected by password access.
This section outlines the menus. A detailed description of the functions immediately follows.
Pressing the number associated with the desired operation permits the operator to access that
function. Pressing the zero key will display the next page of the current menu, where appropriate.
Pressing the pound (#) key will return to the main menu from the sub menus, or return to normal
operation if it is pressed at the main set-up menu.
When a parameter is with a "NEW =" prompt below it, a new value may be entered from the
keypad. Pressing the asterisk (*) key clears the current operator entry, pressing the pound (#) key
accepts the current value, or the new value that has been entered by the operator.
The set-up menu presents the operator with a choice of parameters or functions. Pressing the
"one" key will present a menu of the available PARAMETERS. Pressing the "two" key will
present a menu of the available FUNCTIONS.