Rauch K 51 Instruction Manual - page 36
Machine settings
7
30
7.2
Adjusting the spreading width limiter
The different positions of the spreading width limiter allow for spreading widths
between approx. 0.5 m - 5 m. The spreading width depends on the quality of the
spreading material.
Setting:
Figure 7.2:
Spreading width limiter
[1]
Star knobs for adjusting the spreading width limiter plates
[2]
Spreading width limiter plates
1. Select the side to be set.
2. Loosen the lateral star knob.
3. Loosen the rear star knob.
4. Bring the spreading width limiter plate [2] in the desired position.
Spreading width limiter plate upwards: The spreading width is increased.
Spreading width limiter plate downwards: The spreading width is de-
creased.
5. Fasten star knobs.
The new spreading width is set.
6. Check the spreading pattern (visual inspection or scale) and adjust the set-
ting, if necessary.
NOTICE
Check the proper condition of the spreading width limiter. Damaged or bent el-
ements of the spreading width limiter affect the spreading pattern.
2
1