Rauch K 51 Instruction Manual - page 53
of
64
Maintenance and service
47
9
9.4
Checking the agitator
9.4.1
Dismounting the agitator
9.4.2
Exchanging agitator fingers
1. Pull out the linkage pin.
2. Take out the agitator.
Figure 9.1:
Agitator in hopper
1. Use tongs to push the old ag-
itator fingers out of the agita-
tor.
Figure 9.2:
Agitator with old agitator fingers
2. Use tongs to pull the new ag-
itator fingers in the agitator.
Figure 9.3:
Agitator with new agitator fingers
NOTICE
Install the agitator in reverse order.
When installing the agitator, lubricate it using grease.
Check if the linkage pin is locked in place.