Rauch K 51 Instruction Manual - page 38
Machine settings
7
32
3. Set the spreading vanes back in the direction of number 5.
Using this setting, the spreading material will be ejected later.
4. Screw on the spreading vanes (tightening torque: approx. 7 Nm). Always
use a new self-locking nut when screwing on the vane.
The spreading density on the right-hand side viewed in the direction of
travel is increased.
7.3.2
Increasing the spreading density on the left-hand side in the direction of travel
1. Observe the rotational direction of the spreading disc. See
.
2. Disassemble the screws of the spreading vanes including the corresponding
nuts and washers.
Figure 7.5:
Spreading density on the left in the direction of travel
White arrow: Rotational direction of the spreading disc
Grey arrow:
Adjustment of the spreading vanes in the rotational direction of the spread-
er disc
3. Set the spreading vanes forward in the direction of number 1.
Using this setting, the spreading material will be ejected earlier.
4. Screw on the spreading vane (tightening torque: approx. 7 Nm). Always use
new self-locking nuts when screwing on the vane.
The spreading density on the left-hand side viewed in the direction of
travel is increased.