Rauch K 51 Instruction Manual - page 39
of
64
Machine settings
33
7
7.4
Adjusting the spreading vanes (pushed operation)
7.4.1
Increasing the spreading density on the right-hand side in the direction of travel
1. Observe the rotational direction of the spreading disc.
Figure 7.6:
Rotational direction of the spreading disc
2. Disassemble the screws of the spreading vanes including the corresponding
nuts and washers.
Figure 7.7:
Spreading density on the right-hand side in the direction of travel
White arrow: Rotational direction of the spreading disc
Grey arrow: Adjustment of the spreading vanes against the rotational direction of the
spreader disc
NOTICE
Throw away the self-locking nut after loosening it and replace it by a new one.
See