1. DL manuals
  2. Ritelite
  3. Work Light
  4. K9 30 LED
  5. Operating Instructions Manual

Ritelite K9 30 LED Operating Instructions Manual - Technical Data

Manual is about: Portable Worklight

Summary of K9 30 LED

  • Page 1

    Operating instructions thank you for purchasing the ritelite k9 30 led. This product design represents the latest technology in led portable lighting and is designed to be virtually maintenance free and robust enough to deal with the rigours of a harsh work environment. Portable worklight.

  • Page 2: Operation - Quick Start

    2 thank you for purchasing the k9 30 led operation - quick start although the k930aled is full of features it is still simple to use. When the unit is packed down in torch/storage mode the (on/off) switch is recessed to prevent accidental switch on, yet is still accessible to the user when needed. P...

  • Page 3: Using Your K9 30 Led

    3 using your k9 30 led the k9 30 led can be set up in two basic modes. Torch mode allows the user to carry the unit with the extension arm and head folded down and locked in position. Worklight mode allows the user to site the unit in a suitable position on the ground or on a platform where the exte...

  • Page 4

    Operation - advanced features to use the unit simply press the on button and the light will come on to 100% power/brightness and is ready for use. The additional buttons listed below allow other features to be accessed. (button 1) = on/off (button 2) = mode - flashing, sos, alternate flashing (betwe...

  • Page 5

    5 together to move the diffuser blind up and down in front of the leds, as the blind gradually passes over the leds you’ll notice the projected light pattern change. Sos mode the unit may be set to flash the led’s in the sos sequence if the need ever arises. To do this, switch on, select the power l...

  • Page 6

    6 falls to a point where the unit will automatically switch off. This process will give users adequate time to retreat to an area of safety without being left in the dark. The light should not be switched back on until the battery has been recharged to prevent deep discharge and possible irreversibl...

  • Page 7: Optional Equipment

    7 on board charging an optional built in charging system can be added to allow full automatic charging from any 12 or 24 volt vehicle. A single multi-colour led gives full indication of the charge process. In addition the charger benefits from a vehicle battery protect mode to prevent over discharge...

  • Page 8

    8 on board charging (product code k9-30/vp) the optional in-built charging system (vepac) gives the user the option of charging from a 12 or 24 volt dc vehicle system without the need for additional equipment in the vehicle. The unit has a multi-coloured led to show the state of charging. At initial...

  • Page 9: Storage

    9 storage if the k9 is to be left unused for an extended period of time or the unit is to be put into storage we advise you fully recharge the battery and disconnect the light head plug from the battery unit to prevent any accidental switch on. The unit can then be stored up to 6 months without havi...

  • Page 10: Conformance

    10 4. The internal (vepac) charger shows no led indication for the charging process a) supply cable from vehicle is not connected or there is a poor connection – check supply and connections from the dc power source. B) supply voltage is not high enough to trigger the charger to start – check supply...

  • Page 11: Technical Data

    11 lamp type 30 x high power / flux smd led’s colour temperature 6500 kelvin lumens output at 125% setting ≥5000 nominal life expectancy of led’s 50,000 hours battery type 12v / 22ah high rate discharge sla battery power consumption 43 watts (125% mode) operating modes choice of 4 main modes 1. Work...

  • Page 12: Caution

    Caution • always read the manual fully before use. • use the ritelite approved chargers only, other chargers may cause a detrimental effect on the performance of this unit. • ensure adequate ventilation for this unit whilst charging. • do not stare directly into the light head when powered up. • do ...