Ritelite K9 30 LED Operating Instructions Manual - page 6
6
falls to a point where the unit will automatically switch off. This process will give users
adequate time to retreat to an area of safety without being left in the dark.
The light should not be switched back on until the battery has been
recharged to prevent deep discharge and possible irreversible damage to
the battery.
Performance
The SLK930ALED uses 30 high power LED’s to produce a crisp white light ideal
in a working environment. To efficiently harness and project the light, this unit has
a bespoke lens array with the addition of an infinitely variable focusing system. In
addition, conscious of the lack of an infinite power source, we have developed a
market leading LED driver system to ensure very little energy is wasted with the
majority being converted to light to give a better, brighter light for longer.
Stability
The unit features a pair of fold-out stability enhancing legs that allow
the unit to become an effective tripod system without the
need to carry additional equipment.
Height
Additional height can be achieved with the optional four quicklok
extension poles. This extends the height of the light head from
820mm to 1800mm. These uniquely designed interlocking
poles allow a very simple but unjamable system that can be
quickly deployed yet store in a bespoke retainer on the unit
when not needed.
Remote control system
The optional remote control system allows complete control of
brightness, modes and battery status allowing the unit to be placed
out of reach yet with full control at your fingertips. In addition any
number of extra K930ALED units can be automatically switched
on and controlled by the one remote through the mesh networking
technology employed. One button press can switch on
over a hundred units instantly, each unit allows the signal
to be rebroadcast, so infinite distances and areas can be covered.
Emergency System
Using the same technology as that employed in the remote
control system the optional emergency system can be
configured to detect a failure in a building or site voltage supply
(permanent mains or generator) and automatically signal any
number of K930ALED units to switch on and provide a
wireless emergency lighting system adding new levels
of safety and convenience to the work environment.
K9-30/POLE
K9-30HND
K9-30AMF
(Needs K9-30HDR)