Ritelite K9 30 LED Operating Instructions Manual - page 4
OPERATION - ADVANCED FEATURES
To use the unit simply press the on button and the light will come on to 100% power/brightness and is
ready for use. The additional buttons listed below allow other features to be accessed.
(Button 1) = ON/OFF
(Button 2) = MODE - Flashing, SOS, Alternate flashing (between inner and outer LED arrays).
(Button 3) = BRIGHTNESS - 100%, 125%, 8%, 25%, 50%, 75%.
(Button 4) = SELECT - Inner, outer, both inner and outer LED arrays.
(Button 1) – Used for switching the unit either ON or Off. Note that after switching off allow a few
seconds before switching back on to allow the system to shut down and restart as it checks its battery
status.
Button 2/3/4 – Used to put the light into different profiles as listed above. Switch on the unit
(button 1), select a mode (button 2), then select brightness (button 3), and next select a
channel (button 4) as required.
In addition you can mix and match modes between the two channels, for example you can switch
ON (button 1), select a brightness (button 3), select a channel (inner for example, button
4) then select a mode (button 2, SOS second press). Next select a channel (button 4, outer for
example), then select a mode (button 2, flashing or static) then select the channel (button 4) to
bring both channels on to create different light options.
Pressing and holding the (brightness) button allows dimming up and down regardless of what
brightness mode the unit has been set at.
Light management
The unit features a retractable vari-focus system to allow a tightly focused spot beam through to a fully
diffused flood of light so any working environment can be catered for. Use the two control knobs
4
fig 1 - Controls
Battery Status