Ritelite K9 30 LED Operating Instructions Manual - page 5
5
together to move the diffuser blind up and down in front of the LEDs, as the blind gradually passes over
the LEDs you’ll notice the projected light pattern change.
SOS Mode
The unit may be set to flash the LED’s in the SOS sequence if the need ever arises. To do this, switch
on, select the power level (brightness) you wish to use (8%,25%, 50%, 75%,100% or 125%). Next
press the MODE button twice, pressing the SELECT button allows the inner outer or both channels of
LEDs to be run.
Flashing Mode
The unit may be set to constantly flash the LEDs to provide a warning signal to others. To select this
option first switch on, select a power level you wish to use (8%,25%, 50%, 75%, 100% or 125%) then
press the MODE switch once, pressing the SELECT button allows the inner, outer or both channels of
LED’s to be run.
Battery Status Indication
A low battery warning with cut-off function is included with your K9 30 LED to help prevent deep
discharging the high performance cyclic SLA battery. Deep discharging can lead to reduced battery
performance and life. Note this isn’t a failsafe to prevent damage, the battery must be recharged
after use within 24 hours regardless of how long it has been run.
The user is signalled to help pre-warn of the amount of energy left in the battery able to run the LED
light in 3 ways: 3 colour LED, audible bleeper and flashing of the LEDs on the main panel. As the fully
charged battery discharges, the indicator LED (located next to the power on/off switch) will show green.
As the battery discharges further this indicator LED will change from green through to amber. At this
point the unit will give an audible bleep and blink the main LEDs once to alert the user that a stage has
been reached in the discharge process.
The next change is when the LED indicator changes from amber to red; here again the user will hear
an audible bleep and see a blink of the main LEDs to signal another change nearer to the end of battery
duration.
Finally the indicator LED will change from constant red to flashing red where upon the lamp brightness
will default from any of the power settings down to 25%, the beeper will then sound every 30 seconds
and at the same time the main LEDs will blink once. This process will continue until the battery voltage
INCREASE
FLOOD
INTENSITY
INCREASE
SPOT
INTENSITY
Adjusting Beam from Spot to Flood