Ritelite K9 30 LED Operating Instructions Manual - Operation - Quick Start
2
Thank you for purchasing the K9 30 LED
OPERATION - QUICK START
Although the K930ALED is full of features it is still simple to use. When the unit is
packed down in torch/storage mode the (on/off) switch is recessed to prevent
accidental switch on, yet is still accessible to the user when needed.
Press once to switch on and again for off. Whenever the unit is first switched on it
will default to the 100% brightness setting regardless of how the unit was last used.
At switch on you will hear a bleep from the unit to signal all is well, the battery status
LED, near to the on/off switch, will illuminate to show the units state of charge.
Always remember to put your K9 30 LED on charge after use to prolong the life of the
high capacity rechargeable battery.
CHARGING YOUR K9 30 LED
Whichever Ritelite SLA battery charger you have selected to recharge your K9 30 LED, it was designed
to be left connected indefinitely to the battery unit so your lighting product is always topped up and
ready for use. Your K9 30 LED can be charged and run at the same time, this may be useful when using
the light as an emergency back up should the mains power fail.
It is good practice to always put your K9 30 LED light back on charge even when used for a short
period of time, leaving the unit discharged will have an adverse effect on the longevity of the
battery life.
All the chargers supplied show a combination of lights to indicate each stage of the charging process.
For more details on charging please see the separate instructions included with the charger.
NOTE always charge your K9 30 LED in a dry, well ventilated environment.
Plug charger into spare
socket on rear of unit