Ritelite K9 30 LED Operating Instructions Manual - Using Your K9 30 Led
3
USING YOUR K9 30 LED
The K9 30 LED can be set up in two basic modes. Torch mode allows the user to carry the unit with the
extension arm and head folded down and locked in position.
Worklight mode allows the user to site the unit in a suitable position on the ground or on a platform
where the extension arm can be swung up and locked into position. The height of the extension arm
can then be adjusted by lifting up the locking lever on the extension arm clamp and moving the light
head up or down to the desired position. The locking lever can then be clicked back in to place to hold
the position. The light head can be turned in either direction and the angle can be adjusted using the
clamping handle. The button on the clamping handle allows the user to park the handle at a particular
point, this may be useful to increase or decrease the frictional force applied to the light head when held
in position.
Twin sockets - either socket can be used to charge and / or run the K9 30 LED light. In addition two
light heads can be run simultaneously, or additional 12V equipment such as a phone charger can be
powered. Please contact your point of purchase for further details.
To use your K9 30 LED make sure the plug from the light head is inserted into either of the two sockets
on the battery unit, the red locking ring on the plug should then be turned clockwise to prevent the plug
from being accidentally pulled out.
Your K9 30 LED is designed to work in a harsh environment from low to high temperatures. While high
temperatures can have an adverse effect on LEDs this unit has been designed to counteract this if ever
the situation arose. A temperature sensor monitors the LED light engine output and adjusts the power
output accordingly, but still maintains a slightly reduced light output.
Torch Mode
Worklight Mode