SAB Explorer User Manual - page 16
LNB power : Turn on/off the LNB’ Power.
LNB Frequency : LNB Frequency value
can be selected by using the “ ”, “ ”
buttons and Enter a proper value by
using numeric buttons(0~9).
22KHz : Select 22KHz On/Off/Auto to
control and external tone switch.
DiSEqC : DiSEqC must be used when
using two or more antennas and LNBs.
Select None, DiSEqC 1.0, DiSEqC 1.1,
MOTOR and USALS.
When selecting “MOTOR” Yellow Color button.
1) DiSEqC 1.2 Motor : You can move the
motor to the left or right by pressing the “ ”,
“ ” keys continuously, but when you stop
pressing the “ ”, “ ” keys, the motor will
be stopped.
2) Save : When you press the “OK” key,
current position of the DiSEqC motor will be
saved.
3) Go to Reference : Move to the position “0”.
4) Calculation : The difference between the
current position and the new position of the
current satellite is applied to all the other
satellite also.
5) Limit : You can set the maximum move
extent. You can control “Enable” or
“Disable” mode. When you select “Enable”
“East limit” and “West Limit” will be
activated. Press the “OK” key, then current
position will be restored as each limit.
6) Reset : After select the “Reset” and press
the “OK” key, the original value of motor will
be restored.
Main Menu
- 15 -