Smart-Azz GT28 User Manual - Important Note:
10
IMPORTANT NOTE:
Expanded information on Parameter settings for Tracking,
Geofence and Power Save modes:
The parameter format is: T0003R020C010 (Default)
Password
-I-TRK-TxxxxRxxxCxxx
Example: 1234-I-TRK-T0003R020C010
The first block in this string indicates the time between position checks for the Tracking
and Geofence modes. The default time between these checks containing the GPS data is
3 minutes. This time can be changed to a number between 3 to 9999 minutes. For
example if you want a SMS with updated GPS information every 30 Minutes while it is in
Tracking mode, it should be set as T0030.
The second block indicates the amount of repeated position report SMS messages. When
this number is reached, or if the tracker is stationary for some time, the tracker will
stop the Tracking mode. Default in Tracking Mode is R020 and can be changed to any
number from 1 - 999. If this number is excessive, it may be too large for the battery life.
The third block only applies if the device has Power Save mode ON. It indicates at what
time intervals the tracker will check if a SMS was sent with a new instruction. The time can
be set between 3 - 999 minutes.
Additional Info: The “C” time is also valid if the time interval between GPS position
data is large while it is in “Tracking” mode. The condition to have a check between GPS
data messages when tracking mode is active, is T >2C.)