Smart-Azz GT28 User Manual - page 9
9
4.4 TEL MODE (Overriding caller ID)
The Tracker can be instructed to send the SMS messages to other telephone number than
the caller ID telephone number of the mobile phone from which the original set-up
information or request for information was sent.
This can be useful, for example, in a roaming situation where the callers ID is not always
correctly presented or where the caller is running out of battery power and would like to
switch over to another mobile phone. The tracker can be instructed to override the default
mode to SMS back to a specified telephone number by sending the following string:
Password-I-TEL-xxxxxxxxxxx
xxxxxxxxxxx=
Any subsequent instruction sent to the tracker will override this setting and return to use
the caller ID telephone number.
The only exception is the command:
Password-R-TEL
4.5 GEOFENCE MODE
The geofence mode creates a virtual circular boundary around the unit’s location. The
radius of this circle can be set by the following command:
Password-I-GEOxx
xx
is the radius x 100m.
For example, “GEO01”, means 100m. This is also the default radius.
A confirmation SMS will be sent to indicate the settings.
4.6 SMS Checking Time (Only valid in Power Save mode)
When using the Power Save feature, it may be required to have the device check for a
long period for new SMS messages, while it switches itself ON. This timing can be
changed with the command:
Password-I-CSTANDBY-xxx
xxx
can be 2-255 (minutes)
4.7 DEFAULT MODE
The unit can be re-set to all the original factory default settings,
except the password
,
with command:
Password-I-D
A reply SMS will be sent to the caller ID to reconfirm the default settings.
Ensure that you do not forget your password / code, because you can not reset this
yourself.