Smart-Azz GT28 User Manual - page 11
11
5. Recall mode (To review system data)
5.1 GPS DATA FORMAT
A command can be sent to the tracker to ask for the instructed GPS data format
information. Command for this info request is:
Password-R
-GPS
A reply SMS will be sent with GPS data (DMS, Ddec, Google etc.)
5.2 TRACKING MODE Settings
A command can be sent to the tracker to reveal the last set parameters of
T
,
R
and
C
.
Command structure of the Tracking mode settings request is:
Password
-R-TRK
A reply SMS will be sent to indicate the set parameters of time between GPS checks (T),
number of repeats (R) and incoming SMS check time (C). e.g.
TRK :T0003R020C010
5.3 TEL MODE (Overriding caller ID)
Request for telephone number where the SMS messages will be sent. This can be the
caller ID, or the new instructed Phone number where the SMS data need to be sent to.
Command structure for “TEL” request is:
Password-R-TEL
5.4 GEOFENCE Setting
Request for Status and Radius of the Geofence circle. Command structure request is:
Password-R
-GEO
A reply SMS will be sent to indicate the Geo-fence radius in meters, and if it is on/off.
5.5 POWER SAVE Setting
To find out if Power Save is ON or OFF, this command can be sent:
Password-R-PS
A reply SMS will be sent to inform you whether the Power Saving feature is ON or OFF.
5.6 Battery Voltage
To check the voltage of the internal battery, this command can be sent:
Password-R-BAT
A reply SMS will be sent, indicating the internal battery voltage.
5.7 SMS Checking Time (Only valid in Power Save mode)
To find the SMS Checking time that you may have programmed, this command is used:
Password-R-CSTANDBY
A reply SMS will be sent, indicating the time used.
5.8 BATTERY LOW Warning Setting
To confirm if the BATTERY LOW Warning is switched ON or OFF, this command is used:
Password-R-BATLOW
A reply SMS will be sent, indicating the time used.