Smart-Azz GT28 User Manual - 1.4
5
1.4
QUICK Demo of your Tracker
1.
Install an Activated SIM card in the unit and note down the number.
Ensure that
NO
PIN number is set and that card is activated. Disable call-forwarding and voice
mail messaging. Initially activate the SIM card for the first time with a normal mobile
phone, or whichever way is necessary.
2.
Install the battery in the unit
: Connect the battery plug to the connector inside the
unit. Fully charge it for about 6 hours, or until the red LED turns off. Place unit in an
area of good satellite reception for a few minutes, preferably outside.
3.
Type and Send SMS:
1234-R-TRK
to your tracker mobile phone number and you
should get information about the general Settings of the Tracking Mode.
You should
Receive a SMS after about 30-45 seconds similar to this:
TRK:
T0003R020C010
Note: If you do not receive any reply, please re-check the SIM card and battery
connection. If you still do not receive a reply, this is most likely due to a problem with
the SIM card or GSM network you are attempting to use.
4.
Type and Send SMS:
1234-S
This command will instruct the tracker to send one
Single (S-single) GPS position
(If GPS is not available, GSM cellular network “Node”
information is sent)
. Expect to receive a SMS back with data similar to this: (Or a
Google Maps Link)
Single Mode
Lon 114* 10’ 15.475”E
Longitude coordinates
Lat 22* 17’ 49.146”N
Latitude coordinates
Height: 10.5m
Height above sea level
LOC 07:58:23
Time
16-12-2009
Day, month and year