Smart-Azz GT28 User Manual - 8. Tracking Mode
14
8. Tracking Mode
Command String:
for Tracking Mode
example
1234-T
The Tracking Mode is important in cases where a regular position check is important, for
example, when your vehicle is stolen and you want to track its routing. Tracking mode can
also be automatically activated by the Motion sensor, if it is selected on.
The Default programming settings are:
T
0003
R
020
C
010
The meaning of these parameters are as follows:
T
=
Time between each SMS message with GPS coordinates that the device will send
while it is in the “Tracking” mode.
R
= Number of times the GPS position SMS messages is sent while in “Tracking” mode.
C
= This is the time delay between Checking for any new SMS messages when
operating in Power Save mode.
8.1 If Power Save Mode is ON:
8.2 If Power Save Mode is OFF: (Recommended)
When the Power Saving Mode is switched OFF, then all features of the tracker will
always be in an active state. This means that the GPS coordinates will be available as
in “warm stage” often within about 12 seconds. The parameters for T and R are still
valid and can be set according your own requirements. The parameter “C” however is
not valid any more. Battery life will be shorter with Power Save Off.