Smart Technologies SMART Hub SE240 Administrator's Manual - page 16
10 |
CHAPTER 2
– CONFIGURING YOUR HUB
Connecting Video Sources to Your Hub
IMPORTANT
This section applies to the SMART Hub SE240 only.
You can connect up to two video sources to your SMART Hub SE240. Video sources
include DVD players, VCRs and similar devices. After connecting a video source to
your SMART Hub SE240, you can view its input on your SMART product’s interactive
screen and do the following:
•
Draw digital ink notes.
•
Freeze the display.
•
Take screen captures.
To connect a video source
Connect the video source to the SMART Hub SE240 using the appropriate cables and
connectors.
NOTE
Audio connections are optional.
To configure your hub for
the video source
1. Select
System > Settings
.
The
SMART Hub SE240 Settings
dialog box appears.
2. Press
Input Configuration
.
3. Press
S-Video
if you’re configuring your hub for the first video source, or press
Composite
if you’re configuring your hub for the second video source.
4. In the
Input device name
box, type a name for the video source.
5. Press
Apply All
.
Video Source
Video (A)
Audio (B)
1
4-pin mini-DIN connector
S-video
RCA audio connector set 1
2
RCA video connector
RCA audio connector set 2