Smart Technologies SMART Hub SE240 Administrator's Manual - page 19
13 |
CHAPTER 2
– CONFIGURING YOUR HUB
To configure network
management
(SNMP) settings
1. Select
System > Settings.
The
Settings
dialog box appears.
2. If you have a SMART Hub SE240, select
Network and Conference
, and then
press
Management, Room Control
.
NOTE
The Room Control feature isn’t available with the SMART Hub VE220.
3. Select
Use the settings as the SNMP read/write strings
to use the general
settings for the SNMP read/write strings.
OR
Select
Manually assign SNMP read/write strings
, and then enter the
appropriate information (as supplied by your network administrator) to manually
assign the SNMP read/write strings.
–
Read community string
–
Write community string
4. If you have a SMART Hub SE240, select the
Enable remote management of
SMART Hub SE240
checkbox.
OR
If you have a SMART Hub VE220, select the
Enable remote management of
SMART Hub VE220
checkbox.
NOTE
In SNMP, community strings are text strings that act as s. “Get” requests are
only valid if their community strings match the value in the
Read community
string
box, and “Set” requests are only valid if their community strings match
the value in the
Write community string
box.
5. Type the IP address to which your hub should send traps (as supplied by your
network administrator) in the
Trap destination address
box.
NOTE
Traps are unsolicited, asynchronous events that devices such as the SMART
Hub uses to indicate status changes.
6. Press
Apply All
.