Smart Technologies SMART Hub SE240 Administrator's Manual - page 17
11 |
CHAPTER 2
– CONFIGURING YOUR HUB
Configuring the Display Settings
You can configure your hub’s resolution and time-out settings to work with your
SMART product’s display.
To configure the
display settings
1. Select
System > Settings.
The
Settings
dialog box appears.
2. Press
Display Configuration
.
TIP
The top portion of the
Display Configuration
tab shows information about the
projector or display connected to your hub. You can refresh this information by
pressing
Refresh
.
3. Select a resolution in the
Resolution
list.
4. Select additional options, including how many minutes you want your hub to wait
before it enters sleep mode, shuts down the projector, or displays the device’s
control strip.
5. Press
Apply All
.
Configuring Your Network and
Conferencing Settings
Connect your hub to a network to take advantage of its networking features such as
e-mailing Whiteboard files.
IMPORTANT
You must be familiar with basic networking, Simple Network Management
Protocol (SNMP) and Simple Mail Transfer Protocol (SMTP) to complete the
following procedures. If you aren’t familiar with these concepts, consult an
information technology professional in your organization.
To configure basic
networking settings
1. Select
Systems > Settings.
The
Settings
dialog box appears.
2. Press
Network
for the VE220, or
Network and Conferencing
for the SE240, and
then type a name for your hub in the
Device name/network ID
box.
3. Press the
Network Address
tab, and then select the
Use DHCP (automatically
detect network settings)
option to configure networking settings automatically.