Smart Technologies SMART Hub SE240 Administrator's Manual - page 50
44 |
CHAPTER 4
– MAINTAINING YOUR SMART HUB
6. Select
Administration > Firmware Update
.
The
Settings
dialog box appears.
7. Select the
Bootloader
check box, and then press
OK
.
8. Press
Restart
.
NOTE
The initial reset after updating the firmware can take several minutes.
Upgrading to a SMART Hub SE240
You can upgrade your SMART Hub VE220 to a SMART Hub SE240 for additional
features and benefits, such as:
•
collaboration with remote computers using SMART Bridgit software
•
more extensive audio and video input and output options
•
serial room control capability
•
ability to make notes over video sources
IMPORTANT
Before you can upgrade your SMART Hub VE220, you must purchase a
product upgrade key from your
To upgrade your SMART
Hub VE220 firmware
1. Select
System > Settings
.
2. Press
Upgrade Hub to SE240.
3. Type the product key number into the
Product Key
box.
NOTE
The product key number follows this format: SE-XXXX-XXXX-XXXX-XXXX.
4. If you have an Internet connection, press
Upgrade
.
OR
If you don’t have an Internet connection and are activating your hub manually,
select
Manual Activation
, and then type your activation key.
NOTES
–
If you don’t have an Internet connection, contact
and they will send you an activation key. You
must provide your product key and installation ID in order to receive your
activation key.
–
You only need to request an activation key if you don’t have an Internet
connection and are activating your hub manually.