Smart Technologies SMART Hub SE240 Installation And User Manual - page 13
7
|
CHAPTER 2
– INSTALLING YOUR HUB
Installing Your Hub
Install your hub in three stages:
1. Mount your hub.
2. Connect your hub.
3. Verify that your hub firmware is current.
Mounting Your Hub
NOTE
Use screws and anchors appropriate for the wall on which you’re mounting your
hub (screws may not be supplied, depending on your wall type). If you have a
steel wall, for example, use four toggle bolts to mount your hub. If you’re mounting
your hub on wood, use four wood screws to mount your hub.
You can mount your hub in one of the following configurations:
•
19" (48.3 cm) rack mounting (rack not included)
•
wall mounting
•
tabletop or shelf mounting
•
under-shelf mounting
CAUTION
When mounting your hub, ensure its fans are not obstructed to allow for
proper cooling. If you mount the hub vertically, be sure that the fans face up to
provide optimal cooling.
To mount your hub on a
19" (48.3 cm) rack
1. Attach the mounting brackets to the sides of your hub using the screws provided.
NOTE
There are several methods for attaching the brackets to the side of your hub.
Use the method that works best for your rack. SMART recommends that you
use a method using two mounting brackets aligned with the back of the unit.
2. Mount your hub to the rack.
10-24 × 2" (4)
#8 × 2" (4)